Installation Instructions

手量尺寸若有误差，以收到实际产品为准
If there is any mistake with hand measure, subject to the actual product.
注意：锁紧螺丝前，请保证所有尾线不被螺丝压破，造成短路。
Note: Before tightening the screws, please ensure that all the tail wires are not crushed by the
screws, causing a short circuit.
②贴墙式：将不锈钢壁挂件从人脸设备上取下，在墙面上适当高度置于不锈钢板，用笔做标
注，冲击钻钻四个孔位，胶塞置于孔内，用自攻螺丝先将不锈钢板固定于墙上（如果尾线从
底盒后部出来需要在墙上适当开洞，方便走线；如果尾线从底部出来，只需要用白色大塑料
线槽固定和走线），如图所示！
②Wall-hanging type：Firstly, remove the stainless steel wall hangings from the device. And then