Installation Instructions

①将桌面式置于桌面上，人脸设备放置在支架上方两“L”型卡位上调整好角度即可；适用
于前台访客处。
Place the desktop on the desktop, and place the device on the two "L" card positions above the
bracket and adjust the angle; It is suitable for the front desk visitors.
壁挂式
For wall-mounted
①旋转式：将白色 86 开关底盒置于墙面 1400mm 处，具体高度根据实际使用情况而定，用
笔在底盒四个角处做上标志，用冲击钻钻出四个孔，胶塞置于孔内，用螺丝将底盒固定好，
然后做排线，此法为明装；如果需要内置暗装，侧在墙上画出底盒大小的四方用冲击钻开洞
打线槽，内部镶入水泥估计好，待水泥完全干透后再用螺丝将设备固定于底盒上，如图所示！
①Rotary type : Firstly, put the white 86 switch back box on the wall at 1400mm，and the specific
height should depend on the actual use.And then mark the four corners of the back box with a
pen, drill four holes with an impact drill, place the rubber plug in the hole, fix the back box with
screws, and then do the cable.（This method is installed for surface ）If concealed installation is
required, draw a hole in the four sides of the size of the back box with an impact drill. Cement
inserted inside should be estimated . After the cement is completely dry, fix the device to the
back box with screws, as shown in the figure.