User Manual
9. Cleaning Scheduling
1. Long Press the button. The first 2 digits, indicating the hour, will start blinking.
2. Use the up and down direction buttons to set the current time. Use the left and right buttons to switch from hours to minutes and repeat the
before step.
3.Press the button again to save the settings.
4. To cancel the scheduled cleaning: Set the clock on the remote control to 00:00 am and save it. Switch the robot off for 1 minute and switch on
again.
Note: the robot will emit a beep to indicate all settings have been saved.
Warning: when the remote control is batteries are replaced, the clock and schedule times must be set again.
04
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.