User Manual

1. AUTO Mode
Press on the remote control for it to start cleaning automatically in zig-zag,recognizing which areas it has cleaned and which ones it has not.
The robot will plan the cleaning route automatically as it is cleaning. If during this mode the robot is directed manually, it will re-plan the route and
could repeat already-cleaned areas. In order to ensure efficient cleaning, do not operate it manually during auto mode cleaning.
If the battery is low during the cleaning cycle, the robot will smartly return to the charging base automatically and, once it is fully charged, it will
resume the cleaning from the same point, offering a high-efficiency cleaning.
During the cleaning, the robot will make a brief stop to evaluate the area and plan the cleaning route(this stop will vary depending on the house
conditions).
Note: it is suggested to use the auto mode when cleaning carpets.
2.Suction Power Level Power
Press on the remote control to select the desired power lever. Choose between Eco(low power), Medium(medium Power) and Turbo
(Maximum power).
3.Edge Mode
Press the on the remote control for the robot to start cleaning under this mode, automatically start cleaning along walls, around furniture etc.
Note: press button to switch between the 3 modes: Turbo/normal/Eco.
4. Back-home Mode
Press the button on the remote control to send the robot to the charging base. This mode can be activated during any other cleaning cycle
and the robot will automatically return to the charging base and stop the cleaning process.
The robot will take the shortest route back to the charging base thanks to its map memorizing and the smart back-home function.
When a cleaning cycle has been completed or the robot will also return to the charging base to avoid running out of battery.
Warnings: Remove the water tank from the robot before charging it. If there are obstacles in the room being cleaned, the robot might not be able
to reach the charging base. In this case, take the robot manually.
02