User Manual

ManualsBrandsShenzhen 3irobotix ManualsElectronicsRemote Control

Table Of Contents

Modes

The ﬁrst time the robot is operated,it will map and memorize the whole house by means

of its laser before starting the cleaning cycle.

Note:make sure the light indicator is lit up in blue before starting cleaning, indicating it is

activated.If it is not, press any button on the remote control to wake it up.

Pairing mode:

If the remote control cannot control the sweeper, please follow the steps below:

(1) Press the remote control "Edge" button 5S, the remote control enters the pairing mode, the screen displays 8888;

(2) The remote control receiver module is powered on within 5s and enters the pairing mode. At this time, the pairing signal of the remote

controller is received, and the remote controller returns to normal, the clock shows that the pairing is completed.

(3) If the pairing is unsuccessful, the remote control will display 8888, and will automatically exit the pairing mode after 30S.

REMOTE CONTROL

1. Schedule

2. Power levers(Turbo/Normal/Eco)

3. Back home

4. Time

5. Manual control

6. On/Pause

7.Edge mode

Summary of content (4 pages)

PAGE 1
REMOTE CONTROL 1. Schedule 2. Power levers(Turbo/Normal/Eco) 3. Back home 4. Time 5. Manual control 6. On/Pause 7.Edge mode Modes The ﬁrst time the robot is operated,it will map and memorize the whole house by means of its laser before starting the cleaning cycle. Note:make sure the light indicator is lit up in blue before starting cleaning, indicating it is activated.If it is not, press any button on the remote control to wake it up.
PAGE 2
1. AUTO Mode Press on the remote control for it to start cleaning automatically in zig-zag,recognizing which areas it has cleaned and which ones it has not. The robot will plan the cleaning route automatically as it is cleaning. If during this mode the robot is directed manually, it will re-plan the route and could repeat already-cleaned areas. In order to ensure efﬁcient cleaning, do not operate it manually during auto mode cleaning.
PAGE 3
5.Pause While the robot is operating, press on the App, the remote control or on the robot to pause it and press to resume cleaning. 6.Sleeping The robot will automatically enter sleeping mode after 5 minutes of no operation. Press on the App, the remote control or on the robot to start it up again. Warning: After 12 hours of no operation, the robot will turn automatically oﬀ. The robot will not enter sleeping mode during charging. 7.
PAGE 4
9. Cleaning Scheduling 1. Long Press the button. The ﬁrst 2 digits, indicating the hour, will start blinking. 2. Use the up and down direction buttons to set the current time. Use the left and right buttons to switch from hours to minutes and repeat the before step. 3.Press the button again to save the settings. 4. To cancel the scheduled cleaning: Set the clock on the remote control to 00:00 am and save it. Switch the robot oﬀ for 1 minute and switch on again.