User's Manual

Last change:
2012-3-1
User Manual HL1928M-L/R
Page 14 of 32
5. Connections
5.1 Connecting the flat panel display
Note
All screening precautions contained in the corresponding EMC guidelines must
be observed. If these guidelines are not observed, interference signals could
penetrate the monitor.
Information on cable installation
Only screened cables are permitted for the signal connections.
All connectors should be of screw or locking types (as far as possible).
Signal and power cables must not be routed in the same duct.
The display must not share a power supply with motors or valves (glitches!).
5.2 Connection panel
A connection panel for the signals and power supply is located at the rear of the
flat panel display underneath the little cover.
5.3 Information on additional serial interface (Service Only)
DIN6 connection: you can connect the display via the DIN6 connector to the
computer for firmware updating and monitor test.
Male-DB9 DIN6 BNC VGA DVI-D IEC-3P
Infrared Touch Panel
Only for Right Side
LCD
RS232 Communication