User's Manual
REV A
10
OSD menu.
DVI connection: The connection to the computer can also be made via the
digital single link or via the analog channel of the DVI connection. The
picture quality, noise immunity and radiated interference of the complete
system depend on the cable quality and length.
Serial connection: you can connect the display via the 9pin D-SUB connector
to the computer for firmware updating.
4.1.3 Little cover (attaching)
Lead the monitor end of the cables through the little cover’s cable duct.
Connect the little cover to the rear cover.
4.2 Switching on the display
Switch on the flat panel display using the power switch. The operation LED
lights up.
4.3 Adjusting the image geometry
The display automatically recognizes the used standard, and set-up values for
each standard are preprogrammed. However, depending on the graphics card
used, it may still be necessary to align and size the picture for the selected
standard (see Section 6.1 "Picture adjustment"). Normally auto adjust will
work.
4.4 Adjusting the brightness and contrast
The brightness and contrast must be adjusted for the respective graphics card
(different output levels) in the system on site.
Note on adjustment
− Use the SMPTE test pattern.