User's Manual
Page 19 of 29
already optimized for
digital signals. Manual
changes to these values
are not recommended, as
this can result in an
impairment of picture
quality (loss of grayscales).
Contrast 0…100
Adjustment of contrast.
This allows the brighter
area to be seen more
distinctly. The center point
is in 50 position.
Note: for DVI-D signals
the Contrast setting is
optimized.
Manual changes are not
recommended.
Backlight 0…255 It is used to adjust the
Brightness of the monitor.
Color
Color1
Color2
Color3
User
R G B Gain
R G B Bias
Color 1, Color 2, Color 3
are three fixed color
temperature and can not
be changed. User
temperature can be
adjustable and saved.
H Position
(Analog only)
0…255 Shift picture in horizontal
direction
V Position
(Analog only)
0…255 Shift picture in vertical
direction
Frequency
(Analog only)
0…100 Adjust the frequency and
phase of the input signal.
Hsync Phase
(Analog only)
0…63 Source clock phase
PhaseR
(Analog only)
R ADC clock
phase
0…7
PhaseG
(Analog only)
G ADC clock
phase
0…7
PhaseB
(Analog only)
B ADC clock
phase
0…7
For compensate R,G,B
phase for analog long
cable use.
Display
Settings
Sharpness Interpolation
filter -5 to 5
One of the 11 filters can be
selected for the sharpness
setting to reduce scaling
artifacts. Interpolation
filters depend on the
input resolution. Digital
signals which is used with
1280X1024 resolution can
not be adjusted since each
pixel is controlled by its