User's Manual

Page 9 of 29
VGA connector: the flat panel display can be connected to the computer
system using a VGA Cable on D-sub connection for analog signal. The
display is adapted using an OSD menu.
BNC connector: the flat panel display can be connected to the video
camera using a special BNC-VAG Cable for analog signal. The display is
adapted using an OSD menu.
DVI-D connection: The connection to the computer can also be made via
the digital single link. The picture quality, noise immunity and radiated
interference of the complete system depend on the cable quality and
length.
DP connection: The connection to the computer can also be made via the
DisplayPort connection. The picture quality, noise immunity and radiated
interference of the complete system depend on the cable quality and
length.
Serial connection: you can connect the display via the PS2 connector to the
computer for firmware updating.
4.1.3 Stand base (attaching)
Put the stand base near VESA holes of the monitor. Fasten the stand base