User's Manual

19" LCD MONITOR
REV A
21
The auto functions are used to assist the
automatic setting of parameters. The
quality of settings depends on the picture
contents and the type of synchronization.
Corresponding items in the OSD can adjust
all settings finely.
Auto-
Balance
On/Off
Automatically get input signal match with
the monitor
Auto
-Config
On/Off
Automatically adjusts the image position,
H-Size (or V-Size)
Execute
The selected auto functions are executed.
Note: The quality of the function depends
on the applied picture contents. To get
better effect it is recommended to apply full
screen and including whiteness contents
picture.
Auto function
(Analog input
only)
Auto adjust
on mode
change
On/Off
Enable or disable auto-adjust on mode
change
Language
English
Chinese
Select the language of OSD menu.
Note: English menu is default state.
You can make further settings for the picture source
OSD—Hposition
Adjustment of OSD horizontal position
(Default state is on the bottom right corner
of the screen)
OSD—Vposition
Adjustment of OSD vertical position
(Default state is on the bottom right corner
of the screen)
Hot Key On/Off
Enable or disable the Hotkey. The up key is
used for brightness, down key is used for
Auto Adjust.
Sharpness
Interpolation filter
1 to 7
One of the 7 filters can be selected for the
focus setting to reduce scaling artifacts.
Interpolation filters depend on the input
resolution. A filter is not usually used with
1280X1024 since each pixel is controlled
by its own pulse. The user should
individually adjust the filter depending on
the application. The default interpolation
filter position is 1.
Others
DPMS
setting DPMS on
The backlight is switched off while it is no
input signal. (The default state is DPMS
on)