User's Manual

19" LCD MONITOR

REV A

4.1.3 Little cover (attaching)

Lead the monitor end of the cables through the little cover’s cable duct.

Connect the little cover to the rear cover.

4.2 Power up the display

Power up the display. The operation LED lights up.

4.3 Adjusting the image geometry

The display automatically recognizes the used standard, and set-up values for

each standard are preprogrammed. However, depending on the graphics card

used, it may still be necessary to align and size the picture for the selected

standard (see Section 6.1 "Picture adjustment"). Normally auto adjust will

work.

4.4 Adjusting the brightness and contrast

The brightness and contrast must be adjusted for the respective graphics card

(different output levels) in the system on site.

Note on adjustment

− Use the SMPTE test pattern.

− Adjust the brightness so that image sections with 5% and 0% blackness still

visibly contrast from one another.

− Adjust the contrast so that image sections with 95% and 100% whiteness