User's Manual

BIGTIDE DS01 V3.0
User’s Manual
In order to start the unit, the following steps should be carried out in the given sequence.
4.1 Connecting the power cord and its bracket
Caution
Use a power cord with PE conductor corresponding to the safety requirement of
the respective country of use.
1.
Remove the machine screw over PE sign, and then fix the PE cable on the housing of the unit
with the machine screw.
2.
Put the power cords on the power cord bracket.
3.
Connect the power cords into AC power input receptacle and AC power output receptacle.
Connect AC power output according to the needs of the system.
4.
Install the power cord bracket to the unit with three M3*6 machine screws and tighten.
5.
Connect the power supply socket.
4.2 Start-up mode and connecting DVI cable
4.2.1 Start-up with the DDC of the unit itself
1. Connect DVI-D input connector on the unit to DVI-D output connector on the video source
device with the attached DVI-D signal cable.
2. Power on the unit.
3. Power on the video source device.
4. After start-up is over, connecting DVI output connectors on the unit to the desired display
devices with DVI-D signal cables.
5. Power on the desired display devices.
Note
DDC communication is between the video source device and the unit itself.
4.2.2 Start-up with the DDC of the desired display device
1. Connect DVI-D input connector on the unit to DVI-D output connector on the video source
device with the attached DVI-D signal cable.
2. Connect DVI output connectors on the unit to the desired display devices with DVI-D signal
cables.
- 15 -