User's Manual

Last change:
2013-12-10
Copyright @ Shenyang
Torch-Bigtide Digital Tech.,Co.,Ltd
HL1530
Page 12 of 25
Remark:
1. Parameters
The relevant touch panel parameters are developed between Philips and Ocular. The parameter
settings are pre-loaded by standard firmware loading of the touch panel controller at Ocular factory. The
parameter file shall be under configuration control.
2. Firmware Version
Firmware is released by Ocular to maintain manufacturing configuration control.
Version: F153-1664S-001 V2.0.xcfg
3. Calibration
The P-Cap sensor is matrix based. No calibration is required.
Note1: Test Equipment Setup
The measurement should be executed in a stable, windless and dark room between 20 minutes after the
backlight at the given temperature for stabilization of the backlight. This should be measured in the center of
screen. Test equipment should be equivalent with the following equipment.
Environment condition: Ta=25 ± 2ºC
Note2: Viewing angle is measured as follow:
Note 3: Definition of contrast Ratio (CR):