User's Manual

Page 7 of 26
Use a power cable with PE conductor corresponding to the safety
requirements of the respective country of use. Note for North America:
Molded power supply plugs must comply with the requirements for
hospitals with respect to CSA Std. C22.2 No. 21 and UL 498.The power
supply and signal connections are located on the rear of the color flat panel
display.
Note
Note that the cables are already positioned when you receive the display
(power cable and DVI-D cable). The following steps are only necessary if
you need to connect/disconnect the cables of the scope of supply.
4.1.1 Little cover (removing)
Remove the one screws with a M4 Slot screwdriver (one turn suffices).Pull
down the little cover and then open the little cover and remove it.