User's Manual

Page 2 of 26
2. Declarations
Safety precautions
WARNING:
To avoid risk of electric shock, this equipment must only be connected to a
supply mains with protective earth.
Appliance coupler
or separable plug of is used as isolation means to isolate
the equipment from mains supply.
Accessory equipment connected to the analog and digital interfaces must
be certified according to the respective IEC/EN standards (e.g.IEC/EN950
for data processing equipment and IEC/EN 60601-1 for medical
equipment).
Furthermore all configurations shall comply with the valid version of the
System standard IEC/EN 60601-1-1.Everybody who connects additional
equipment to the signal input connector or signal output connector
Configures a medical system, and therefore responsible that the system
Complies with the requirements of the valid version of the system standard
IEC/EN 60601-1-1. If in doubt, consult our technical service department or
your local distributor.
Regular maintenance and calibration are recommended
Please note that liquid crystal displays such as the HL1916S SERIAL do
not have a failure rate of zero and image parameters may change over time
(e.g. luminance or discoloration). Please ensure that all measures are
taken to prevent injuries or incorrect diagnoses. Regular maintenance and
calibration are recommended.
Correct and safe operation of the flat panel displays is dependent on proper
transport, storage, installation and assembly, as well as careful operation
and maintenance. The units must only be used for applications for which
monitors are normally used. The information in the Section "Technical data"
must be observed exactly.
For the sake of safety, the following precautions must be observed:
Only use a perfect power supply cable
A damaged power supply cable may result in a fire or electric shock. When
disconnecting the power supply cable, always do so by holding the plug.
Only use the same type of fuse
T2A/250V
Medical Equipment
With respect to electric shock, Fire and mechanical
hazards only in accordance with ANSI/AAMI
ES60601-1:2005＆CSA C22.2 No.60601-1:2008