User's Manual

Page 12 of 26
5.3 Information on additional serial interface (Service Only)
Serial connection: you can connect the display via the RJ11 connector to
the computer for firmware updating and monitor test.
5.4 Analog and digital inputs (DVI,VGA,DP)
DVI socket
With DVI digital signal through DVI cable.
VGA socket
Use VGA cable for VGA input.
DP socket
With DP digital signal through DP cable.
5.5 Power supply connection
Note
Device fuses can not be exchanged outside of the repair centers.
The display power supply is connected using an appliance plug. Only use
the power cable supplied in the delivery, or a cable with PE conductor and
appliance socket to DIN 49 547, IEC 320.
Caution
A power cable with PE conductor must be used which corresponds to the
safety requirements of the respective country of use.