User's Manual

Page 10 of 26
mount by mounting screws (see page 6 table Mounting Screws for details).
4.2 Switching on the display
Switch on the flat panel display using the power switch. The operation LED
lights up (color: green, provided the timing has been recognized – please
refer to section 7 "Fault diagnostics").
4.3 Adjusting the image geometry
The display automatically recognizes the used standard, and set-up values
for each standard are preprogrammed. However, depending on the
graphics card used, it may still be necessary to align and size the picture
for the selected standard (see Section 6.1 "Picture adjustment"). Normally
auto adjust will work.
4.4 Adjusting the brightness and contrast
The brightness and contrast must be adjusted for the respective graphics
card (different output levels) in the system on site.
Note on adjustment
− Use the SMPTE test pattern.