User's Manual

19" LCD MONITOR
REV A
22
DPMS on
The backlight is switched off while it is
no input signal. (The default state is
DPMS on)
DPMS setting
DPMS off
The backlight will not switch off if it is
no input signal. Only switches off along
with the power switches off.
Status Current display settings can be called
here in the respective picture mode.
Working hours of display, firmware type
and version, OSD version, configuration
version, current source, current timing of
input signal, current LUT, current
temperature inside the monitor.
Service
Level2
Service level LUT select and factory settings recall: Contrast; Brightness;
Backlight; Setting1; OSD position; corresponding LUT factory recall.
(The default state is Gamma2.2LUT)
DICOM Select DICOM LUT
CIE Select Gamma CIE LUT
Gamma 1.8 Select Gamma 1.8 LUT
Gamma 2.0 Select Gamma 2.0LUT
Gamma 2.2 Select Gamma 2.2 LUT(default)
Native Select panel native characteristics
Factory reset Set to factory default setting ,Gamma@6500K,200cd/m
2
Quit OSD
menu
Accept
changes
Reject
changes
Quick OSD menu and either save or
reject the changes.
If you have reached this menu
unintentionally, you can return to the
main menu using the Set key.
OSD is
locked
If this message is displayed, you do not
have the authority to carry out the
changes in the OSD menu.
Please contact your servicing partner in
this case.
Notice: To enter the Aadv. Option press 1xSet key +2x Down. key