User's Manual
Table Of Contents
- Customer Specification
- HL1916
- 1. SCOPE
- 2. ELECTRICAL PERFORMANCE
- 2.1 Power Supply
- 2.2 Power Management
- 2.3 Signal Interface
- 2.3.1 Signal Specifications
- 2.3.2 D-SUB Connector and Pin Assignment (Figure1)
- 2.3.3 Digital Visual Interface and Pin Assignment (DVI)
- 2.3.4 Control Interface
- 2.4 Product Features
- 2.5 Screen Performance
- 2.5.1 Standard Testing Conditions
- 2.5.2 Brightness
- 2.5.3 View angle
- 2.5.4 Brightness Uniformity
- 2.5.5 Contrast radio
- 2.5.6 White Color Coordinates
- 2.5.7 Response Time
- 2.5.8 Color Gray
- 2.5.9 Gamma Curve
- 3. OPERATING GUIDE
- 4. MECHANICAL SPECIFICATIONS
- 5. ENVIRONMENT CONDITONS
- 6. DEFECT, SCRATCH and DUST
- 7. NOTICE FOR HANDING
- Appendix 1 Preset Timings
Last change: 27
th
, Oct. 2005
Copyright @ SSME (SIEMENS
Medical Equipment Ltd.) All
rights reserved
HL1916
Page 28 of 32
(8) If the liquid crystal material leaks from the panel, it should be kept away from the eyes or mouth.
In case of contact with hands, legs or cloths, it must be washed away thoroughly with soap.
(9) Protect the module from static which may cause damage to the CMOS Gate Array IC.
(10) Use fingerstalls with soft gloves in order to keep display clean during the incoming inspection
and assembly process.
(11) Do not disassemble the module.
(12) Do not pull or fold the lamp wire.
(13) Do not adjust the variable resistor located on the module.
(14) Protection film for polarizer on the module should be slowly peeled off just before use so that
the electrostatic charge can be minimized.
(15) Pins of I/F connector should not be touched directly with bare hands.