User's Manual
Table Of Contents
- Customer Specification
- HL1916
- 1. SCOPE
- 2. ELECTRICAL PERFORMANCE
- 2.1 Power Supply
- 2.2 Power Management
- 2.3 Signal Interface
- 2.3.1 Signal Specifications
- 2.3.2 D-SUB Connector and Pin Assignment (Figure1)
- 2.3.3 Digital Visual Interface and Pin Assignment (DVI)
- 2.3.4 Control Interface
- 2.4 Product Features
- 2.5 Screen Performance
- 2.5.1 Standard Testing Conditions
- 2.5.2 Brightness
- 2.5.3 View angle
- 2.5.4 Brightness Uniformity
- 2.5.5 Contrast radio
- 2.5.6 White Color Coordinates
- 2.5.7 Response Time
- 2.5.8 Color Gray
- 2.5.9 Gamma Curve
- 3. OPERATING GUIDE
- 4. MECHANICAL SPECIFICATIONS
- 5. ENVIRONMENT CONDITONS
- 6. DEFECT, SCRATCH and DUST
- 7. NOTICE FOR HANDING
- Appendix 1 Preset Timings
Note 1: a. every dot herein means Sub- Pixel (Each Red, Green, or Blue Color)
b. Damaged less than half size of sub-pixels is not counted as defect
c. Dots darker than half brightness of sub-pixel are not defined as bright dot defect and dots
brighter than half brightness of sub-pixels is not defined as dark dot defect.
d. The definition of range A is included in range B.
Note 2: Panel Pixel Defect comply with ISO 13406-2 class 2
6.3 Polarize Defects
(Unit: mm)
Items Criteria
Scratches Linear 0.02 <= W <=0.05, 1.0<= L <=10.0, N <=5
Dent Circular 0.15<= D <=0.5, N<=5
Where W: Width
L: Length
D: Average diameter = (a + b) / 2
Note
:
a. Average Diameter
b. Linear: a>2b, Circular: a<=2b
c. Extraneous substances which can be wiped out, like Finger Print, Particles,
are not considered as a defect.
d. Defect which is on the black matrix (outside of Active Area) are not considered as a defect.
6.4 Foreign Material
(Unit: mm)
Items Criteria
Linear 0.02<= W <=0.1, 0.3<= L <=3.0, N <=5 Foreign
Material
Circular
0.2<= D <=0.5, N<=5
Last change: 27
th
, Oct. 2005
Copyright @ SSME (SIEMENS
Medical Equipment Ltd.) All
rights reserved
HL1916
Page 26 of 32