User Manual

Last change:
17
th
Jun, 2013
User Manual DSC1913-D/DC
Page 17 of 33
5.4 Analog and digital inputs (DVI-I, DP, BNC)
DVI-I connector
Connect VGA-DVI-A cable with DVI-I connector (male) for the analog input to
the DVI- connector (female). Or connect DVI-D cable for digital signal.
DP socket
With DP digital signal through DP cable.
BNC connector
Use BNC-DVI-A cable (optional) for BNC input.
5.5 Power supply connection
Note
Device fuses can not be exchanged outside of the repair centers.
The display power supply is connected using an appliance plug. Only use the
power cable supplied in the delivery, or a cable with PE conductor and
appliance socket to DIN 49 547, IEC 320.
Caution
A power cable with PE conductor must be used which corresponds to the safety
requirements of the respective country of use.
5.6 Serial interface
Caution
No other units may be connected to the service socket. Connection or
disconnection of a unit may only be carried out by servicing personnel or those
trained by them. A Serial Spot Meter or Universal Serial Luminance Meter must
not be connected in the presence of patients.
The display has a serial RS 232 RJ11 interface sockets to update the SW.
5.7 DC-5V power supply
Caution