User Manual

Last change:
17
th
Jun, 2013
User Manual DSC1913-D/DC
Page 16 of 33
5. Connections
5.1 Connecting the flat panel display
Note
All screening precautions contained in the corresponding EMC guidelines must
be observed. If these guidelines are not observed, interference signals could
penetrate the monitor.
Information on cable installation
Only screened cables are permitted for the signal connections.
All connectors should be of screw or locking types (as far as possible).
Signal and power cables must not be routed in the same duct.
The display must not share a power supply with motors or valves (glitches!).
5.2 Connection panel
A connection panel for the signals and power supply is located at the rear of the
flat panel display underneath the little cover.
5.3 Information on additional serial interface (Service Only)
Serial connection: you can connect the display via the RJ11 connector to the
computer for firmware updating and monitor test.
DP
DC 5V
RJ11 for RS232
DVI-I IN LET 3P IEC TYPE
PE