User's Manual

19" LCD MONITOR

REV A

Connect the cables to the display.

To remove the power cable ,first remove the strain relief .It is used for

protecting the connection. As the following figure shows. When fixing the

power cable, reverse the steps.

DVI-A connector: the flat panel display can be connected to the computer

system using an VGA-DVI-A Cable or the analog channel of an DVI

connection. for analog signal. The display is adapted using an OSD menu.

DVI-D connection: The connection to the computer can also be made via the

digital single link or via the analog channel of the DVI connection. The

picture quality, noise immunity and radiated interference of the complete

system depend on the cable quality and length.

DP connection: The connection to the computer can also be made via the

digital single link or via the DP connection. The picture quality, noise

immunity and radiated interference of the complete system depend on the

cable quality and length.

Serial connection: you can connect the display via the RJ11 connector to the

computer for firmware updating.