User's Manual

Last change:

2015-1-23

HL1936(HL1936SMT-L

/R internal) For GE

Page 32 of 37

7. NOTICE FOR HANDING

Handing

(1) When the module is assembled, it should be attached to the system firmly using all mounting

holes. Be careful not to twist or bend the modules.

(2) Because the inverters use high voltage, power should be disconnected before it is assembled or

disassembled.

(3) Refrain from string mechanical shock and /or any force to the module. In addition to damage,

this may cause improper operation or the module and CCFT backlight.

(4) Note that polarizes are very fragile and could be easily damaged. Do not press or scratch the

surface using the harder than a HB pencil lead.

(5) Wipe off water droplets or oil immediately. If you leave the droplets for a long time, staining

and discoloration may occur.

(6) If the surface of the polarizer is dirty, clean it using some absorbent cotton or soft cloth.

(7) The desirable cleaners are water, IPA (Isopropyl Alcohol) or Hexane. Do not use Ketone type

materials (ex. Acetone), Ethyl alcohol, Toluene, Ethyl acid or Methyl chloride. It might damage

to the polarizer due to chemical reaction.

(8) If the liquid crystal material leaks from the panel, it should be kept away from the eyes or mouth.

In case of contact with hands, legs or cloths, it must be washed away thoroughly with soap.

(9) Protect the module from static which may cause damage to the CMOS Gate Array IC.

(10) Use fingerstalls with soft gloves in order to keep display clean during the incoming inspection

and assembly process.

(11) Do not disassemble the module.

(12) Do not pull or fold the lamp wire.

(13) Do not adjust the variable resistor located on the module.

(14) Protection film for polarizer on the module should be slowly peeled off just before use so that

the electrostatic charge can be minimized.

(15) Pins of I/F connector should not be touched directly with bare hands.