User Manual

19" LCD MONITOR
REV A2
22
You can make further settings for the picture source
OSD—Hposition
Adjustment of OSD horizontal position
(Default state is on the bottom right corner
of the screen)
OSD—Vposition
Adjustment of OSD vertical position
(Default state is on the bottom right corner
of the screen)
Hot Key On/Off
Enable or disable the Hotkey. The up key is
used for brightness, down key is used for
Auto Adjust.
Sharpness
Interpolatio
n filter 1 to
7
One of the 7 filters can be selected for the
focus setting to reduce scaling artifacts.
Interpolation filters depend on the input
resolution. A filter is not usually used with
1280X1024 since each pixel is controlled
by its own pulse. The user should
individually adjust the filter depending on
the application. The default interpolation
filter position is 1.
OSD Lock
Timer 120sec
If there is no action in 2 minutes, the OSD
will be locked automatically. The OSD’s
content will be saved.
Others
Status Current display settings can be called here
in the respective picture mode: Operate
hours of display, firmware version, OSD
version, configuration version, current
source, current temperature, current timing
of input signal, current LUT inside the
monitor.
Service
level 2
Settings in this menu must only be carried out by service person*