User Manual

19" LCD MONITOR
14
REV A2
5. Connections
5.1 Connecting the flat panel display
Note
All screening precautions contained in the corresponding EMC guidelines
must be observed. If these guidelines are not observed, interference signals
could penetrate the monitor.
Information on cable installation
Only screened cables are permitted for the signal connections.
All connectors should be of screw or locking types (as far as possible).
Signal and power cables must not be routed in the same duct.
The display must not share a power supply with motors or valves (glitches!).
5.2 Connection panel
A connection panel for the signals and power supply is located at the rear of
the flat panel display underneath the stand and its cover.
6-PIN RJ45 RS232
CONNECTOR
Digital input （Female）：DVI
Power supply connection
USB CONNECTOR
Analog VGA input（Female）：
15pin D-Sub connection
GND