User Manual

Last change:

2013-3-20

Torch-Bigtide Digital Tech.,Co.,Ltd

HL1530

Page 23 of 23

Diameter > 0.8 mm, Quantity = 0

Lines, Linear Fibers or Scratches in the viewable area

Width < 0.02 mm, Disregard or ignore

0.02 mm < Width < 0.04 mm, Length < 20 mm Min. distance between blemishes: 10 mm

0.04 mm < Width < 0.08 mm, Length < 5 mm Quantity < 2, min. distance between: 20 mm

0.08 mm < Width < 0.10 mm, Length < 2 mm Quantity < 1

Width > 0.1 mm, Refer to circular blemish criteria: (a+b) / 2

Note 1: Bubbles or contamination outside the viewing area are considered acceptable.

Note 2: If a blemish can be wiped off or blown away using a compressed air gun, the touch panel is

considered acceptable.

Note 3: Defects described above should be found at IQC (Incoming Quality Control), or prior to TFT display

bonding or completed manufacturing assembly.

Note 4: Glass chips that do not impact functionality and only observed from the back side are considered

acceptable.

Note 5: Glass cracks or fractures are not acceptable.

FCC Statement:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.