User Manual
Table Of Contents
- Please read the manual carefully before operating the product.
- Tubing may have cracks due to wear, which results in overflow of fluid from the tubing. In that time human body and instruments may be harmed. So, users must check frequently and change the tubing in time.
- Please stop pump head rotating when replacing the tube or changing the tube position, otherwise it may cause fingers or clothes got caught.
- There are moving parts of the pump head inner, before opening the upper block, it must be carried out according to the following requirements:
- Ensure the pump is isolated from the main power supply.
- Ensure there is no pressure in the tubing.
- If the tubing has defects, ensure the liquid in the tubing is discharged to other containers or drain tubing.
- If transferring dangerous liquid, the user must wear protective clothing and eye protection.
- 1. Product Introduction
- 2. Pump Head Instruction
- 3. Dimension Drawing
- 4. Pump Head Technical Specification
- 5. Function Instruction
- 6. Troubleshooting
- 7. Maintenance
- 8. Warranty and After Service
Shenchen Pump AMC Series
- 1 -
1. Product Introduction
AMC series pump head has flexible positioning mechanism, where users can install
and remove the cartridge easily. Flexible pressure tube design to extend the service
life of the tube. Stepless adjustment of pressure tube gap to improve the transmission
accuracy between channels. 304 stainless steel roller assembly, two types of roller
structures: 6 rollers and 10 rollers. Multichannel, low flow rate transferring, compact
structure, suitable for supporting instruments.
2. Pump Head Instruction
Knob
Back board
Front board
Cartridge
2.1 Pump Head Installation
Usually, the pump head is installed on the pump drive. Below is the pump head
installation instruction in case the pump head is separate from the pump drive when
you receive it. When users need to change pump head, please refer to the below
instruction:
First, remove all the cartridges from the pump head.
Connect the pump head shaft to the coupler on the pump drive. And then use 4