User's Manual

Please check the function of losing control protection is normal before driving
Confirmation method:
1, Open the transmitter first and then open the receiver power;
2, set the lose control of protection function connect to the receiver (39 pages);
3, turn off the transmitter;
4, confirm the function under the lose control protection the throttle and channel can operate in
a setting position.
Lose control of protection function is when the receiver can not receive the signal, Let the
actuator set the position move in advance Make the hurt to the lowest safety auxiliary function
But if the position set in advance is dangerous position, it will cause the posite effect.
Case: the throttle setting is safe in the midpoint position.
Attention Point For The Battery
Do not use wet hand . To Plug the charger to avoid the risk of electric shock.
Before driving, make sure the transmitter for battery charging.
Driving power is insufficient, there will be danger burst.
When the Nickel cadmium battery of the transmitter is charging, please be sure to use the
dedicated charger.
Charging exceeds the specified value will be tend to abnormal heating, rupture, battery fluid
leakage .Injury, fire damage, blindness may happen .
Avoid nickel cadmium battery link end may result in short circuited.
If the short circuit will be on fire, abnormal heat, will cause burns or fire.
Ni/MH Ni/Cd
Using NiCd/NiMH battery
11
Careful
Careful
Warning
Important Notes