User's Manual

(6). DELAY

(7). Governor mixing

This function is to delay the aerobatics or throttle cut when the

helicopter is in the air so that to avoid the big trim change.

The Delay function provides a smooth transition between the trim

positions whenever OFFSET, REVO. MIXING, or THROTTLE HOLD

functions are turned on and off.

This function is to set the governor.

The Governor mixing function is used to adjust the GV-1(Governor)

speed settings(rS1,rS2,rS3) from the transmitter.

Set up a delay on all 3 channels to ease the transition from one flight condition to another so there are

“hard jumps”.

Steps:

1. Open the DELAY function.

2. Adjust AIL response as needed. (Ex: aileron to +8%)

3. Repeat for other channels.

4. Close menus and confirm slowed transitions.

Set up a Gv1 governor to use both channels into the reeiver and switch between the governor settings auto-

matically when changing conditions.

Consider setting the battery FailSafe settings and other helpful functions on the GV-1 itself.

Steps:

1. Open and activate the GOVERNOR function.

2. Optional: change cut-off channel to channel 8 and assign switch and direction for on/off(channel 8).

3. Optional: change switch assignment to select governor settings. Ex: select switch that selects the conditions.

4. Adjust governor speed settings per switch position or condition as needed.(Ex: defaults are fine.) Allows head

speed adjustment from transmitter.

5. Close the function.

WFT09

INSTRUCTION