User's Manual

(5). Trim offset setting
This function is to adjust the servo trim at hovering state.
Optional separate trims in addition to those for the normal condition.
This function is used to automatically change the trim of a helicopter,
for example, when transitioned from hover to flying at high speed. A
clockwise-rotation rotor helicopter tends to drift to the right at high
speed, so an aileron offset may be applied to offset the helicopter to
the left. The necessary elevator offset varies with model geometry, so
it must be determined by noting collective pitch changes at high speed.
The rudder offset is affected by both revo. Mixing and trim lever movement
while in the offset function.
(4). HI/LO PIT setting
This function is to set the high and low pitch position at di-
fferent flying modes.
20
Set up separate trims for each of the three idle-up conditions.
Adjust the idle-up 2 rudder trim to correct for torque at high speeds.
Steps:
1. Open the OFFSET function.
2.Change switch setting to COND.
3. Select IDL2
4. Adjust trim settings as needed.(Ex: rudder to +8%)
5. Close menus and confirm difference in trims between nornal and idle-up 2.
WFT09
INSTRUCTION