User's Manual
11. Trim step setting
12. Throttle cut setting
This function is to changes the rate at which the trim moves when
the TRIM LEVER is activated. The range is from 0 to 250. Generally
larger trim steps are for models with large control throws or for first
flights to ensure sufficient trim to properly correct the model. Smaller
trim steps are later used to allow very fine adjustments in flight.
This function is to shut off the engine at the end of a flight. The
engine can be stopped with one touch of any switch, eliminating the
neeto move the trim to kill the engine and then readjust prior to each
flight. The helicopter THR_CUT includes an ON/OFF throttle position
(normally a little above idle). You must move the THROTTLE STICK
back below the set point before the THR-CUT function can be reset,
to avoid sudden engine acceleration.
16
Setting Method
Use up or down button to select Trim step setting, OK button is to enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button to adjust the size of the step,
3. Repeat as desired for other channels.
3. Press EXIT after setting.
Setting Method
Use up or down button to select Throttle cut setting, OK button is to enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Choose desired switch, and position which activates the function.
3.With THROTTLE STICK at idle, adjust the rate until the engine consistently shuts off but
throttle linkage is not bingding..
3. Press EXIT after setting.
WFT09
INSTRUCTION