User's Manual

4. End point
It is to adjust the end of individual servo’s travel. The range is
from 0% to 120%.
5. Sub trim
Sub trim makes small changes or corrections to the neutral position
of each servo. Range is -120 to +120, default setting is 0.
13
Setting Method
Use up or down button to select End point, OK button is to enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button or OK button to set the travel value. Press OK for a while backs to
default.
3. Press EXIT after setting.
Setting Method
Use up or down button to select Sub trim, OK button is to enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button or OK button to set the trim value. Press OK for a while backs to
default.
3. Press EXIT after setting.
We recommend that you center the digital trims before making
Sub trim changes, and that you tryto keep all of the Sub trim
values as small as possible. Otherwise, when the Sub trims
are large values, the servo’s range of travel is restricted on
one side.
WFT09
INSTRUCTION
Channel
Side
Value
Channel
Value
Side