User's Manual

3. Set dual rate
Press direction button to select “D/R”, edit it. Edit one or two parameter.
+/- buttons can increase or decrease the value.
Press the OK button is to back default.
4. Set exponential
Press direction button to select “EX”. Exponential can adjust aileron, throttle
and rudder sensitivity as the stick at the middle.
5. Set curve point (normal/advanced)
The box under “EX” shows the curve points.
Select “Curve setting” in More setting function list.
Normal curve setting--7 curve points setting.
Select the curve point by left and right direction button, the point is appeared as
dashed in curve picture.
Use +/- button to set the value. Press OK button backs default.
Advanced curve setting--Increasing or decreasing curve point.
Use +/- button to select the curve point, press OK to edit. Use up or down button
to set the point value, use up or down button to set the point position. Press OK to finish.
The editing point is appeared dashed in the right picture.
There are 11 points in D/R curve, you can edit every point. At editing state, press
+ button can insert a curve point. Press - button can delete a curve point.
2-11 points are supported.
6. Press EXIT after all the values are finished setting.
12
WFT09
INSTRUCTION
3. Servo direction reverse
This function is to change the direction of the servos movement.
Setting Method
Use up or down button to select Servo reverse, OK button is to enter editing.
Steps:
1. Use direction buttons to select editing part.
2. Use +/- button or OK button to switch the servo movement direction.
3. Press EXIT after setting.
Direction (Rev-reverse, Nor-normal)
Channel