User's Manual

Selection Refer the instroduction on page 17
Selection Refer the instroduction on page 17
Selection Refer the instroduction on page 18
Selection Refer the instroduction on page 18
Selection Refer the instroduction on page 19
Selection Refer the instroduction on page 19
1 Monitor
2 Dual rate
3 Servo reverse
4 End point
5 Sub trim
6 Trim
27
7.Flaperon mixing
●Function
●Settings
This feature is to use two mixers in the aileron, to make aileron have a mixer like flap function.
Press the power button to boot into the / down keys can choose to the edit item.
"Preferences" menu,use Up / Down arrow to 2. Selected the options, press the + / -
key to edit the
select the "Flaperon mixing", press OK key to data. Long press OK key to restore the default
enter the function interface, as above. values.
The steps of settings is as follows:1. Using the up 3. Set successfully, press EXIT key to retrun.
Introduction of System Settings Menu
Introduction of Parameter Settings Menu
1.Model parameters
2.Model Setting
3.
4.Stick settings
5.Stick calibration
6.
7.Tone settings
8.Contrast settings
9.Power supply scheme
10.Version Information
Coaching / Simulation
Restore factory settings
Selection Refer the instroduction on page 16
Selection Refer the instroduction on page 16
Selection Refer the instroduction on page 15
Selection Refer the instroduction on page 15
Selection Refer the instroduction on page 15
Selection Refer the instroduction on page 14
Selection Refer the instroduction on page 14
Selection Refer the instroduction on page 13
Selection Refer the instroduction on page 13
Selection Refer the instroduction on page 13
INSTRUCTION MANUAL
WFT07 REMOTE CONTROL DEVICE
Airplane Function