Shen Zhen WFLY Technology Development RADIO CONTROL SYSTEM : User's Manual : Page 25

21

10.Throttle holding Settings

●Function

●Settings

Throttle holding settings can set in when throttle adjustment within ± 75% .

cut landing , fixed the throttle servo in the a low Switch K1 work for this function.

speed position , throttle holding position can be

In the "Preferences" interface,use Up / Down keys function , with + /

- keys to implement.. 3. In the

to select the "throttle holding settings", press OK "Location" item to set the throttle holding location,

key to confirm enter the function interface, as with a + / - key to implement. Long press OK key to

above. The steps of settings is as

follows:1, the restore the default values. 4. Set successfully, press

first to use the arrow keys to select Edited Item.2. EXIT key to return.

. In the "mixing" item to set on or off this mixing

11.Timer

●Function

●Settings

As the different of each Helicopter fuel tank size alert with short-ring ,when from 10 seconds to the

and engine speed, will lead to vary different flight time,each second alert with long-ring, regular

time.The Timer function can alert you in warning arrival will blew tips.

tone landed the plane safely on

the ground before ◆ can set the timing and countdown.

you used up the fuel . ◆ Control way : K2 switch control, throttle control,

◆The maximum time of the timer is 99 minutes automaticel work after boot.

and 59 seconds. In the work every 1 minute to tips

time, from 20

seconds to the time, each second

In the "Preferences" interface,use Up / Down key to restore the default value.

keys to select the "Timer", press OK key to 4. In the "mode" item set mode. With a + / - key to

confirm enter the function interface, as above. implement.

The

steps of settings is as follows: 5. In the "Control"item set the control switch, with + /

1, First to use the arrow keys to select Edited - key to implement.

Item. 6. In the "position" item set the throttle control

2. In the "Timer" item set the timer. location. With a + /

- key to implement.

3. In the "minutes ..seconds .. " option to set the 7. Set successfully, press EXIT key to return.

time, with a + / - key to implement. Long press OK

Helicopter Functions

INSTRUCTION MANUAL

WFT07 REMOTE CONTROL DEVICE