User's Manual

Introduction of the Parameters Settings Menu
1.Monitor
●Function
●Settings
The monitor function is to monitor and confirm the channel operation state.
In the "Preferences" interface, use Up / down keys each channel action condition
to select the "Monitor", press OK key to enter the
function interface, as above.Then can monitor
2.Dual Rate Settings
●Function
●Settings
Dual Rate function is by setting the switch to control rate.
change the aileron, elevator, and rudder of the
In the "Preferences" interface, use Up / down keys 3. Settings the D / R, Use the arrow keys to select
to select the "Dual rate ", press OK key to enter
the the "D / R 'in screen, when the screen light off,
the function interface . As above. then enter the edit mode of this function.
The steps of settings is as follows (You can choose settings single parameter or two
1. Select the required channel (eg, aileron, parameters at the same
time ), then press + / - keys
elevator etc.). Use the + / - key to select the to change the values ,long press OK key can be
required channel, confirmed with OK key. recovered to the default value.
2. Select the K3 switch position (position 0 or
position
2). Use the + / - button to select the
required location .
Cur ve poi nt and Cur so r line
Sel ec t ac tion
(Ai leron, El ev at or,Rudder )
Switch K3
End poi nt
Expon ent ial
Cur ve poi nt display
Cur ve
17
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
Helicopter Functions
INSTRUCTION MANUAL
WFT07 REMOTE CONTROL DEVICE