User's Manual

14
图3
●Settings
Press the MENU key to boot into the "System 1, first to use the up / down arrow keys to edit the
Settings" menu,use Up / Down arrow keys to selected item.
select the "trainer / Simulator", press OK key to 2. Press OK button to confirm, then press the right
enter the function interfacet, as shown above. arrow keys to determine. Reboot to take effect.
The steps of setting is as follows:
4.Control Stick Settings
●Function
●Settings
Control stick settings function allows users Totally have four models to choose .
to freely setting the higher of the stick according
to personal preferences . As shown. This machine
Press the MENU key to boot into the "System 1. First to use the arrow keys to select
the edited
Settings" menu,use Up / Down keys item .
to select the "stick settings" and press OK key to 2 Use Up / Down key to implementation Stick Mode .
enter this function interface, as shown above 3. Set successfully, press EXIT key to exit.
The steps of settings is as
follows:
5.Stick Calibration
Joystick calibration function allows users to preferences .
change the throttle side according to personal
●Function
●Settings
Press the MENU key to boot into the "System (throttle /elevator on the top edge, aileron / rudder on the
Settings" menu,use Up / Down keys to select right edge), press the OK key (in this case the maximum
"Stick calibration" and press OK key to enter the value has been
calibrated), into the stick minimum (low)
function interface, as Shown above. Specific calibration. 5.When the "low" highlighted, put the stick
settings, follow these steps: 1.First to use the arrow gently leaned on the left (throttle / elevator on the lowest,
keys to select the edited item, (example aileron Aileron /
rudder on the left edge), press the OK key (while
calibration). 2.Put the calibrate joystick placed in the the stick minimum calibrated OK). 6.At this memont the
midpoint of the channel position, options Up / Down - bottom of the screen displays "confirmation / reset" and
key implementation the control calibration
. 3.Selection press to OK key ,all the calibration is completed,
into the Figure 3. When the "middle" highlighted, press automatically return to the superior menu, use the
OK key (this time the Point calibrated is OK), into the arrow keys selected to re-enter Calibration
stick maximum (high) calibration. 4.When the "high"
Procedures.
highlighted, put the stick gently leaned on the right
1---ileron
2---evator
3---hrottle
4---Rudder
Helicopter Functions
INSTRUCTION MANUAL
WFT07 REMOTE CONTROL DEVICE