User's Manual

1. Start up Screen
The starting up screen displays the voltage, timer, model, aileron,
throttle, elevator and rudder state.
2. Menu Screen
You will find the “System setting”, “SYS setting”, “More setting”.
When turn on the power switch, the LCD displays as follows.
A. System setting
Turning on the transmitter and pressing the menu key, the LCD
displays the follows.
1. MONITOR
2. DUAL RATE & EXPONENTIAL SETTING
3. SERVO REVERSE
4. END POINT
5. SUB TRIM
6. SWASH PARAM SETTING
7. AUXILIARY CHANNELS
8. THROTTLE CURVE SETTING
9. PITCH CURVE SETTING
10. REVOLUTION MIXING
11. TRIM STEP SETTING
12. THROTTLE CUT SETTING
13. FLY MODEL SWITCH
14. THROTTLE HOLDING SETTING
15. FAIL SAFE
16. TIMER
17. ADVANCED
18. LANGUAGE
Voltage
Start time
Timer A
Timer B
Timer C
Model type
Throttle trim
display
Rudder trim display Aileron trim display
Elevator trim display
Idle
Editing mode and function introduction
Note: Press EXIT, the screen shows you the model name.
Setting method:
1. Use direction keys change
parameters or use the up/down keys to
browse the functions. Use the left/right
key to switch pages.
2. Press OK to enter submenu.
The submenu function is described in
the next chapter.
3. Press EXIT key to go back from
previous menus. Data is set automatically.
Model name
10
WFT08S
INSTRUCTION