User's Manual

CH1 CH2
WFT06X R/C System
User Manual
WFT06X R/C System
User Manual
Mixture Function for Triangle Airplane
When B, F are down and D, E are up, it is used for triangle airplanes.
CH1 aileron and CH2 elevator are mixed together, which can make the
aircraft turn up, turn down and turn around.
WFT06X-B Function Introduction
This model is a popular model with 4 channels. It is mainly used
for airplane or helicopter with mixture functions.
The main functions are as follows：
(1) Channel 1, 2, 4 power adjusted functions.
(2) Standard 4 channel functions.
(3) At airplane state, channel 1 & 2 mixture function: Triangle wing (ELEVON).
(4) Channel 1, 2, 3, 4 reverse switch.
(5) Sound-and-light hint notification for low power: when the battery voltage is below 8.8V, the
power indicator light 1S/1S glitters and buzzes. And when it is below 8.3V, the power indicator light
0.5S/1S glitters and buzzes at the same time.
Switch Function Instruction:
(A) Turn up A, the movement of channel 1, 2, 4 is 100%, and
turn it down is small movement.
(B) Channel 1 & 2 mixture function: Triangle wing(ELEVON).
(C) Channel 1 is reverse switch for aileron. Pulling it down
is to make it in normal mode, and pulling it up is to make
it act in reverse.
(D) Channel 2 is reverse switch for elevator. Pulling it down
is to make it in normal mode, and pulling it up is to make
it act in reverse.
(E) Channel 3 is reverse switch for power. Pulling it down
is to make it in normal mode, and pulling it up is to make
it act in reverse.
(F) Channel 4 is reverse switch for rudder, pulling it down is to
make it in normal mode, and pulling it up is to make it act in
Reverse.
A-1/ 2
1 2 3 4
A-NOR
( A ) ( B ) ( C ) ( D ) ( E ) ( F )
D/R
REV
△
▽
NOR
This model has functions of CCPM helicopte and airplane,
but emphasizes on helicopter.
WFT06X-C Function Introduction
The main functions are as follows:
(1) Pitch Zero Trim (PZT).
(2) Pitch Length Trim (PLT).
(3) Be used for CCPM helicopter, airplane, car, boat. Standard 6 channels output.
(4) Compatible with simulation softwares.
(5) Channel 1, 2, 3, 4, 6 reverse switch.
(6) CCPM helicopter pitch reverse.
(7) CCPM state, aileron reverse switch.
(8) CCPM state, elevator reverse switch.
(9) Normal flying and 3D flying. The transmitter will alarms if it is turned on in a Idle-up state, and no output.
(10) Dual rate.
(11) Throttle hold.
(12) Gyro sensitivity adjust.
(13) Idle-up throttle adjust.
(14) Sound-and-light indicator for low power: When the battery voltage is below 8.8V, the power indicator light
1S/1S glitters and buzzes. When it is below 8.3V, the power indicator light 0.5S/1S glitters and buzzes at the
same time.