User's Manual

WFT06X-A Function Introduction
This model has functions of both airplane and helicopter,
and emphasizes more on airplane.
Switch Function Instruction
(A) At helicopter state, pulling A down to put off mixture function of channel 3 to channel 4, when pulling it up
it will comeback the function. But the mixture function to channel 6 is stable, which is irrelevant with this
switch.
(B) Pulling B down is airplane state and pulling it up is helicopter state.
(C) At airplane state, pulling 1, 2, 4, 6 down the dual rate is ±100%; when pulling them up, the dual
rate will be ±125%.
(D) At airplane state, pulling D down make switches have no mixture function, but pulling it up will cause them
have the function.
(E) At airplane state, when D is pulled up, pulling E down cause channel 1 & 6 mixture function (Flaperon);
pulling E up will cause channel 2 & 4 mixture function(V-TAIL）.
(F) At airplane state, when D is pulled up, pulling F up it works as the mixture function of channel 1 &
2(Triangle wing ELEVON), and D function doesn’ t work at that moment.
(G) Channel 1 is reverse switch for aileron. Pulling G down is to make it in normal mode, and pulling it up is
to make it act in reverse.
(H) Channel 2 is reverse switch for elevator. Pulling H down is to make it in normal mode, and pulling it up is
to make it act in reverse.
(I) Channel 3 is reverse switch for power. Pulling I down is to make it in normal mode, and pulling it up is to
make it act in reverse.
(J) Channel 4 is reverse switch for rudder. Pulling J down is to make it in normal mode, and pulling it up is to
make it act in reverse.
(K) Channel 6 is reverse switch for screw-pitch/ flaperon .Pulling K down is to make it in normal mode, and
pulling it up is to make it act in reverse.
H4ON
A-4/2
REV
△
▽
R
NO
H4OFF
A-1/6
HELI
A-3D
A-MIX
1
2
3
(A)( B)( C)(D)(E)(F) (G) (H) (I) (J) ( K)
A-1/2
4
6
ACRO
A-NOR
A-NOR
A-NOR
AIL
ELE
THR
RUD
PIT
(1) At airplane state, channel 1, 2, 4, 6 is a switch for dual rate(D/R) variable: from ±100% to ±125%.
(2) At airplane state, channel 1 & 6 mixture function: Flaperon.
(3) At airplane state, channel 4 & 2 mixture function: V-tail.
(4) At airplane state, channel 1 & 2 mixture function: Triangle wing(ELEVON).
(5) At helicopter state, channel 3 mixture function is to channel 4 & channel 6.
(6) At helicopter state, channel 3 mixture function is only to channel 6.
(7) Channel 1, 2, 3, 4, 6 reverse switch.
(8) Normal mode can be used in car model and boat model.
(9) Sound-and-light hint notification for low power: when the battery voltage is below 8.8V, the power
indicator light 1S/1S glitters and buzzes. And when it is below 8.3V, the power indicator light 0.5S/1S
glitters and buzzes at the same time.
Mixture Functions of Helicopter
Having the mixture functions of channel 4 will unlock the tail. So when this
happens, you can pulling A down and pulling B up.
when A and B switches are up, channel 3 will control the mixture function of
channel 4 and 6.That is, when pushing channel 3 control rod, both the main
rotor's distance and the tail rotor’s distance will be enlarged. So if the rotor
distance become nearer, you should only turn the reverse switch of the
corresponding channel.
Model with Ordinary Gyro:
Model with Special Functions Gyro:
1CH6CH
When B, E, F are down and D is up: the aileron uses two
servos. If you turn the channel 6 switch, the left and right
aileron can fluctuate at the same time. Pushing channel
1 rod to right-and-left direction can make the left and right
aileron differential.
The left aileron is connected to CH6 and the right one is
connected to CH1.
Mixture Functions of Airplane's Flaperon
2CH
4CH
(4CH)
(2CH)
When E, D are up and B, F are down: It is used in V-tail
aerocraft. CH2 elevator and CH4 rudder's mixture
function will cause the aerocraft to descend /ascend
or swerve.
Airplane's V-TAIL
WFT06X R/C System
User Manual
WFT06X R/C System
User Manual