User's Manual

Operation of Transmitter
Functions of Control Rods
MODEL 1
(Channel 2:Elevator) (Channel 1:Aileron)
(Elevator TRIM) (Aileron TRIM)
Ascend
Descend
Left
Right
high
Low
Left
Right
high
Low
Left
Right
Left
Right
Ascend
Descend
(Channel 4:Elevator) (Channel 3:Power)
(Rudder TRIM)
(Power TRIM)
MODEL 2
(Channel 3:Throttle) (Channel 1:Aileron)
(Power TRIM)
(Aileron TRIM)
（Channel 4:Rudder）
（Channel 2:Elevator）
(Rudder TRIM)
(Elevator TRIM)
Channel 6: Screw-pitch/Flaperon Action
The angle adjusting of the flaperon is for the airplane state, and the adjusting of the main
screw-pitch is for helicopter state.
Channel 5: Landing Gear/Gyro Action
This channel is for switch variable. It is a switch to control landing gear when used for airplane
state, but it will be a switch for gyroscope when used for helicopter.
Channel 4: Rudder Action
Control the swerve of the aerocraft. Turning the control rod to left will make the head of the
aircraft turn left, and turning it to right will make the head turn right.
Channel 3: Throttle Operation
Control the power. Pulling the control rod down will minish down the power group, and boosting
the control rod up will increase the power group.
Channel 2: Elevator Action
Control the aerocraft to descend or ascend. Pulling the control rod down will drive up the head,
and the aeroplane will ascend. Boosting it up will make the head downhill, and the aeroplane
will descend.
Channel 1: Aileron Action
Control the right-and-left lean of the aircraft. To level the slantwise aircraft, you must make
the control rod act in reverse direction. Otherwise, it will make the aircraft overturn .
WFT06X R/C System
User Manual
WFT06X R/C System
User Manual
R
2. Operation Instructions
1. Code matching
A. Press Set to start the receiver or press Set and hold. The orange
LED flashes, indicating the receiver waits for the code matching signal.
2.4G system can automatically recognize WFLY PPM.
WFLY 2.4G Operation instructions
B. Press Power to start the transmitter. Press Power again to enter the code
matching function. The orange LED of the receiver lights up. Press Power and
hold until the orange LED flashes,indicating the receiver enters the code
matching status.
C. If the code matches successfully, the green LED of the transmitter lights up.
The LED of the receiver is off.
The receiver is on. The red LED lights up. Wait for the
powering up of the transmitter.
The receiver is on. The green LED of the transmitter
lights up. The LED of the receiver is off.
3. Fail Safe Setting
A.Power on receiver.
B.Press Set to start transmitter and hold for 2 seconds.the green LEDflashes,
indicating the transmitter enters the code matching status.
C.The Green LED of receiver flashes, the output data of transmitter is the
output data of Fail Safe Set receiver
D.Due to the heavy interference or out of normal range, the receiver enters Fail
Safe. The Red LED of receiver lights when it is in Fail Safe status.
Flash