Product Instruction

Press down the rocker to exit the calibration, and the RGB light goes out.
6. Elimination of problems：
6.1 When the device cannot be started, the built-in battery may be dead. Please charge the handle with a USB cable.
6.2 In case of accidental crash or disconnection of the handle, keep the distance between the handle and the device not
too far and reconnect.
7.ATTENTIONS：
7.1 Avoid strong vibration. Do not disassemble, modify or repair by yourself.
7.2 Avoid storing in humid, high temperature, lampblack and other places.
7.3 Avoid water or other liquids entering the handle, which may affect the function of the handle.
7.4 There is a battery inside, please do not fall the handle into the fire, it may explode.
7.5 The charging voltage of this product shall be USB4.5-5.5V DC power supply, otherwise it may not be charged or the
product may be damaged.
7.6 If not in use, press and hold the "HOME" button for 3 seconds to close the handle.
7.7 Children should use the product under the supervision of an adult.
7.8 If you have any quality problems or suggestions, please contact the seller or after-sales personnel.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority
to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure
condition without restriction.