Users Manual

第
5
页，总
8
页
4.8.2
In the game, use the card of the corresponding game as prompted
。
4.9
Handle vibration adjustment function
：
After connecting the machine, TURBO key + left 3D up and down adjust motor vibration intensity, the fourth gear can
be adjusted: 0(vibration off)-- 30% (weak)-- 70% (medium)-- 100% (strong), default power on 70% (medium).
weak
：
LED1 flash, motor low vibration
。
Medium: LED1+LED2 flash, vibration in the motor
。
 strong：LED1+LED2+LED3 flash, motor strong vibration。
Off: all LED off, motor does not vibrate。
Note: Handle vibration adjustment has memory function。
4.10 TURBO (Supports continuous transmission in any mode or connection mode)
4.10.1 The buttons for setting the TURBO function are A, B, X, Y, L, R, ZL, and ZR。
4.10.2 TURBO (Supports the TURBO function in any connection mode and in any mode)
4.10.3 TURBO setting：
Normal connection Settings: When you press T and function keys at the same time, the Orange indicator of the Tur
bo key blinks (6 times per second).
Automatic serial setting: Press "T and function key" again under normal serial setting, and automatic serial setting is
triggered when the turbo key is pressed. The orange indicator blinks (4 times per second)
。
4.10.4 TURBO Clearing: If you press T and at the same time, the continuous transmission function of the key is
disabled. The Turbo key orange indicator does not blink。
4.10.5 All TURBO keys are cleared：
Press T and - at the same time to cancel the sequential key function.
Press the "HOME" switch to return to the HOME screen and cancel the serial button function for all Settings.
T+ right rocker can set the continuous speed 5 10 15 continuous speed can be reflected in the orange flashing tubr
o lamp.
4.11
MACRO function (support programming function in any connection mode and in any mode)
。
4.11.1
At the same time, press any programming key M(M1-2) and then hold down T. The white indicator of the Turbo
key is on to enter the programming state
。
4.11.2
Press the action keys that need to be programmed, such as left joystick (up and down left and right), cross key (up
and down left and right), ABXY, L\R\ZL\ZR\L3\R3 for input
。
4.11.3
After editing, press the programming key M, and the white light will turn off, while the orange light will turn
on. (Each group of macro programming, programmable 16 action keys, when the action keys more than 16, the
end of programming, white light off
。