Users Manual

第
4
页，总
8
页
Sleep 10 minutes when LED1+LED2 light at the same time
；
Sleep 20 minutes LED1+LED2+LED3 light at the same time
；
Sleep off: LED1+LED2+LED3+LED4 light on at the same time
。
When the handle is connected back, it will enter the sleep state without connection for 30 seconds
。
4.6.2
When the handle is connected back, it will enter the sleep state without connection for 30 seconds
。
4.6.3
In the first pairing state, the gamepad enters the sleep state without connection for 60 seconds
。
4.6.4
When the handle is in working state, it will enter sleep after 5 minutes without any button or shaft action
；
4.6.5
When sleeping, press the HOME button of the gamepad to connect and wake up the switch host
。
4.6.6
By default, the controller will wake up when there is no action for 5 minutes
4.6.7
Sleep current: less than 50uA
。
4.7
Handle sensing /3D rocker calibration
：
Under sleep state, press L3+R1 to enter calibration, and the four LED lights of the handle flash alternately in two gr
oups. At this time, place the handle on the horizontal desktop, and press the + key of the handle. After releasing t
he key, sensor calibration and 3D rocker calibration will be automatically completed 3 seconds later.
(3D rocker calibration: it can solve the problem that the rocker does not return when the user mistakenly touches t
he rocker during startup/reconnection)
4.8 swipe card use：
4.8.1 Swipe card location map：