Installation Guide

Important Safety Instructions
SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
CAUTION WARNING ATTENTION AVERTISSEMENT
This manual contains important instructions for EV700. When using electric products, always follow basic
precautions, including the following.
1. Read and follow all warnings and instructions before installing and operating the WPT charging station. Install and
operate only as instructed. Failure to do so may lead to death, injury, or property damage, and will void the Limited Warranty.
2. Only use licensed professionals to install your WPT charging station and adhere to all national and local building
codes and standards. Before installing the WPT charging station, consult with a licensed contractor, such as a licensed
electrician, and use a trained installation expert to ensure compliance with local building and electrical codes and standards,
climate conditions, safety standards, and all applicable codes and ordinances. Inspect the charging station for proper
installation before use.
3. Always ground the WPT charging station. Failure to ground the charging station can lead to risk of electrocution or fire.
The charging station must be connected to a grounded, metal, permanent wiring system, or an
equipment grounding conductor shall be run with circuit conductors and
connected to the equipment grounding terminal or lead on the Electric Vehicle Supply Equipment (EVSE). Connections to the
EVSE shall comply with all applicable codes and ordinances.
4. Install the WPT charging station using a WPT approved method. Failure to install on a surface that can support the
weight of the charging station can result in death, personal injury, or property damage.
Inspect the charging station for proper installation before use.
5. This charging station is not suitable for use in hazardous locations. Do not install EV700 near flammable, explosive, or
combustible materials.
6. This device should be supervised when used around children.
7. Do not put fingers into the electric vehicle connector.
8. Do not use this product if the input power cable or EV charging cable is frayed, has broken insulation, or any other
signs of damage.