Installation Guide

Mounting the EV700
1. The bracket will need to be mounted independently of the EV700 charging device. Remove the joiner screw
on the bottom side of the device to separate the bracket.
2. Locate the stud closest to the NEMA 6-50 (or 14-50) socket on which you wish to mount the EV700. The
mounting bracket allows for vertical or horizontal screw installation.
2a. If your stud is visible, add an additional stud for
horizontal and vertical screw applications.
2b. If you are mounting on sheet rock wall, we recommend
using a 50lb hollow wall anchor at all four anchor points.
3. Place the mounting bracket against the wall between 39-43 inches (990-
1092mm) above the ground.
4. Make sure the bracket is evenly mounted using a level tool, and make
markings with a pencil.
5. Drill pilot holes for each anchor screw.
6. Install the mounting bracket using the washers, and anchor screws.