Operating Instructions

IV. Technology Specs:
Charging voltage
5V
Charging current
150mA
Working current
35mA
Shut off current
41uA
Charging time
About 2H
Working time
About 7H
Battery capacity
280mAh
Bluetooth Ver.
Version 5.0
Bluetooth audio
processing
DSP and
A2DP(Advance Audio
Distribution Profile)
Bluetooth frequency
2.402-2.480GHz
Bluetooth
transmission distance
10M
Bluetooth MIC
effective distance
0.5~2M
Bluetooth
transmission output
power
6dbm
V. Troubleshooting:
No
response
on power
.Toggle the RX-TX key and long
press the power button again
.Plug in the charging cable to
charge the Bluetooth player for 5
minutes before turning it on
Can't play
. Make sure the connected device
is working properly
·Clear bluetooth pairing and repair
Bluetooth
·Is the audio cable plugged in
properly
Can’t
charge
. Please unplug the charging cable
and re-insert it
. Try switching to another charger
No
reaction on
and off
Long press the "on/off" button for 8
seconds to resume factory
Settings and start up again
VI. Warm tips:
1. Do not use this product in a dusty and humid
environment with extremely high and low
temperatures.
2. Do not drop the product to avoid surface damage
or breakdown.
3. Do not disassemble the product,if you have any
questions, please contact your dealer
4. Due to continuous improvement and
enhancement of technology,changes in product
performance and functionality are subject to
change without notice.
VII. Packaging
1. Manual 2. Main device
3. Audio line 4.Micro-USB Charging line
FCC Statement
NOTE: This equipment has been tested and found to
comply with the limits for a
Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a
residential installation. This equipment generates
uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this
equipment does cause harmful interference to radio
or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
-Connect the equipment into an outlet on a circuit
different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV
technician for help
Changes or modifications not expressly approved by
the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.