User's Manual

3.Operation Instructions
3.1. First Use
3.1.1.You can find the OBD port of your car at several locations in the figure. The port is shown in the
lower left corner
3.1.2. Connect OBD, use Type C to connect with product, and turn on the product.
3.1.3. Start the car and the HUD will starting up about 3 seconds later (The start-up time of HUD is slightly
different for different types of vehicles)
3.1.4. Open the image combiner to the vertical position
3.1.5. Adjust the combination of the base and the product, and fine-tune the angle of the image combiner
to find a position where the image can be seen in the driving position, mark this location.
3.1.6. Remove the base adhesive protection paper and attach the main body and the base to the center
console. And make the final fine-tuning.
3.1.7. Insert the mobile phone data cable into the USB interface and use the cable clips to organize the
data cable and OBD cable.