User's Manual

1
Hardware installation and introduction
1. Open the battery compartment at the bottom of the feeder, insert the
Micro USB power cord into the connector at the bottom; and extend
the power cord out along the designed wire guide. You can also insert
3 pieces of D cell batteries which will enable the feeder to work
automatically according to your scheduled feeding plan even without
an external power supply. Turn on the power switch.
Battery
The back-up battery is designed as a short-term alternative for when the
external power supply is cut. When the pet feeder works on battery
back-up, it will go into sleep mode and some functions will be limited:
a. When there is battery supply only, the feeding voice recording will
be played only once before feeding the pets. It will not play during
Power
switch